If you have not already given me your emailid/phone number - please do so when you come to the lab exams.
As announced earlier in your class, there will be a 3 hour pre-final examination in Electronic Circuit Analysis covering all the fundamental concepts in the subject.
The Date and timings of the exam are as follows :
Date : 03-05-2013
Time : 08:30AM to 11:30PM
Before you write the main exam, I will be posting a number of question papers for your self-assessment. You NEED NOT write the answers but are strongly advised to look in to the text books for the most appropriate answers. If you have any doubts about your confidence in answering the question if it comes in the exam, then I suggest you write the answer for practice.
Please try to spend lots of time in WRITING your answers and NOT JUST READING and MEMORISING. You will see a great difference in your presentation.
Today, I am giving a question paper which was recently given to JNTU-Anantapur ECE students.
They too have the same syllabus as you do.
Note : The last two questions were given to those poor students from : OUT OF SYLLABUS. Hence they are marked in RED. You need not answer them or be worried about them.
*********************************************************************************
Electronic Circuit
Analysis – JNTU - Anantapur
Set - 01
1. (a) Draw the small signal model of
CB amplifier and derive expressions for Ri ,Ro,Ai,Av
(b).Rs=1k,RL=10k,find Av,Avs,Ai,Ais,Ri,Ro assuming the values of CE theoretically.
2 (a) Compare emitter follower and
Darlington emitter follower configurations with respect to:
(i) Current gain.
(ii) Input impedance
(iii) Voltage gain
(iv) Output impedance.
(b) If four identical amplifiers are cascaded each having f =
100 Hz, determine the overall lower
3 dB frequency. Assume non interacting
stages.
(c) Write a short note on Gain-Bandwidth product of amplifiers.
3 (a) Draw hybrid – model for a
transistor in the CE configuration and explain the significance of
every component in this model.
(b) Draw the small signal equivalent circuit for an emitter
follower stage at high frequencies.
Derive equation for higher cut off
frequency.
4a.Compare series fed and transformer coupled class
A amplifiers..?
4b.Draw the ckt of transformer
coupled amplifier and explain the operation graphically.
5a.Draw a simple BJT tuned amplifier
ckt and its ideal response characteristic.
5b.Calculate fs,BW and Q of tuned
transformer amplifier with RL=10k,C=30pF and L=10 mH and
turns ratio =10
6a.What are the main advantages of
class-C RF amplifier and explain the operation with
necessary waveforms?
6b. Mention the three methods of
stabilisation of double tuned transformer coupled amplifier
circuit performance against the feedback path through the parasitic
capacity b/w i/p and o/p
and mention reasons for neutralisation schemes.
7a. Explain the limitations of unregulated
power supplies. To derive regulated DC o/p
from Ac
mains what are the important building blocks.Explain about each block.
7b.A certain voltage doubler has 20 v_rms
at its input .what is the o/p voltage? sketch the ckt
indicating the input terminals and PIV rating of the diode for
(i)voltage tripler (ii)quadrapler
8a. Draw the ckt of 7805 voltage regulator and
explain its operations
8b. 7824 regulator IC can deliver a
maximum current of 700 mA.design a ckt using 7824
to deliver current of 3mA.
*******************************************************************************************************
HoD-ECE-SVIT